Meshtastic

980 readers

1 users here now

A community to discuss Meshtastic (https://meshtastic.org/docs/introduction)

founded 2 years ago

MODERATORS

[email protected]

Heltec v3 now in a power cycle loop (midwest.social)

submitted 4 months ago by [email protected] to c/[email protected]

9 comments fedilink hide all child comments

Just got a new case for my v3 and now all it is doing is going through a power cycle loop showing the splash screen and nothing more. Pulled the battery and tried only USB power but same result.

Has anyone seen this issue? Running the current beta firmware and it was working fine for a few weeks so i doubt it's a SW issue.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 4 months ago* (last edited 4 months ago) (1 children)

Usually I'll get that when the battery is too low. USB power/charging normally does the trick for me :/

[–] [email protected] 2 points 4 months ago

under USB power with no battery it still occurs. Looking like an odd case issue.