this post was submitted on 12 Nov 2023
10 points (91.7% liked)

homeassistant

15159 readers
16 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @[email protected]

founded 2 years ago
MODERATORS
[email protected]
[email protected]
10
HA autodiscovery (lemmy.world)
submitted 2 years ago by [email protected] to c/[email protected]
6 comments fedilink hide all child comments
 

Hey guys,

I'm having some trouble getting back into home assistant. I was running fine on an RPi with HA in docker, but during some tinkering on another project broke the whole thing and it was easier to start from scratch.

Since last time though, I've installed a mesh WiFi system (TP link Deco). These are running in Access Point Mode. My new HA is up and running again, but hasn't auto discovered anything. I recall being surprised last time by the amount of things it found and how easily. I think there are some network settings preventing proper auto discovery, can anyone give me any tips?

Thanks in advance!

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 2 points 2 years ago

Thanks! I've seen this phrase before when hunting around some other forum posts. How can I check this? I assume on my router or on the access points? I can't see anything in the Deco app about this, I found this link that suggests it might not be supported?