homeassistant

14941 readers

4 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @[email protected]

founded 2 years ago

MODERATORS

[email protected]

Sengled wifi lightbulbs not keeping color settings? (programming.dev)

submitted 1 year ago by [email protected] to c/[email protected]

10 comments fedilink hide all child comments

Hey all, hoping I can gain some insight into an issue I'm having with my sengled lightbulbs. Basically I have two scenes set up in HAS, one "default" scene that has all the lights at 100% brightness with soft white and another that is for movies that turns off all the light except two and modifies the color value to be a more orange, and lower brightness.

My issue is when trying to set the default scene, the color values of my pair of lights don't seem to keep the color temperature. The color picker will immediately clear any value I set after 2 seconds, and go back to the previous scene's brightness and color. I can usually go into the sengled app to reset the color to what I want but this is far from ideal.

It's important to note that I'm using the unofficial sengled api addon from HACS and I am not using the zigbee versions of the lightbulbs (I don't have a zigbee-compatible usb stick yet).

Is this an api limitation or something else I'm missing? Would the zigbee versions work better than the WiFi ones? My router is practically right next to the light bulbs so I doubt that's the issue.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 1 year ago (1 children)

Yeah, the ones I have left work fine at the very edge of my network. But I had serious network issues using them throughout the house until I switched to better bulbs that work how Zigbee devices are supposed to.

[–] [email protected] 1 points 1 year ago (1 children)

After I posted the above comment, I saw other people claiming they've had issues getting them to display traditional incandescent color values. I have not had that issue with them, either. There was something I had to set in HomeAssistant for the bulbs, I think, perhaps in the color picker UI, to allow the selection of those colors, but once I found that, no issue. I don't think I even had to manually re-pair them when I switched Zigbee channel to avoid my Wifi.

Now that I've said this, one will probably start showing blue instead of white or something, of course.

[–] [email protected] 1 points 1 year ago

The problems I had were more network related because I didn't have enough repeaters, because I didn't realize SengLED had ignore the Zigbee spec and made their bulbs only endpoints. Once I put other bulbs in that worked properly, the network issues disappeared.