Using cedar 2x4s cut to 1.5x3. Planning to seal with outdoor polyurithane varnish. Any thoughts on the design thus far?
this post was submitted on 29 Apr 2024
23 points (100.0% liked)
Woodworking
7477 readers
40 users here now
A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @[email protected] whose father was inspired to start woodworking by Norm and the New Yankee Workshop.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Don’t die. It’s a prototype and I’ll need like 7 of those. I cut two lefts rather than a left and right.
Do you have other joinery gong on, or are those legs relying on pocket screws to hold the load? Is it going to stand up to the racking forces that chairs take?
Just screws and glue so far in the design
are you comfortable with that joint taking that load?