Trees

It works the same whether im using diamonds or hash rosin or bubble hash as long as its got cannabanoid oil to extract. It sounds like your using a PID ball injection dab rig, I knew someone who used something like that but never got one myself.

Instead of putting the dab directly in the rig and onto the balls, try getting some vape wool, make a concentrate ball and put the ball in the bucket onto of balls. Then use a carb cap to seal up the bucket as you hit on it. If the balls scorches the wool bad your temps may be too high.

Remember its gonna be a dry hit for the first pull gotta take the wool ball back out of the bucket and rip it open once the oil is liquid to get that surface area.

As for temps, I've found 428F to be where its at in general. Thats what my air max limits at and it does completely vaporize the oils after a few hits. when I went past 428F for my desktop vape I risked flower combustion. Since you have balls you set the PID a little higher to make up the difference.

Generally theres two ways you can go about it. You can have it run hot to vaporize all the dab at once in one big milky hit. This instantly destroys all the lower temp terpenes responsible for subtle flavors. It is also inefficient because the human lungs can only absorb so much oil per inhale. A single lung burster fully milked out concentrate dab hit is almost certainly way more than needed (though quite fun!) your lungs just cant absorb it all.

The other way is to run it just warm enough to get a gentle stream of vapor over a couple of hits. This preserves the terpenes/flavors much better than instantly flashing the dab, and will actually get you higher than one big hit as you can space it out over a minute or two for better absorption of oil. Finding that simmering melting point is a lot tougher than just cranking up the heat, but its worth it.