No just the phone while walking around the setup at different distances
bistdunarrisch
joined 2 years ago
Austria :)
More details on Telescopius: https://telescopius.com/pictures/view/231589/deep_sky/ic-1378/elephant-s-trunk/by-maxi_franzi
Ha thanks!
Thank you!
Full resolution and more details: https://telescopius.com/pictures/view/226214/deep_sky/ngc-3063/bode-s-and-cigar-galaxy/by-maxi_franzi
Thank you for your nice comment!
The stripes are called walking noise/ pattern and often show up when not using a tracking mount and not using dithering.
Because not every pixel of your camera captures signal exactly equally bright you‘ll see this difference along the movement of the sky as it gets accumulated with every subframe. The only way to get rid of it is to vary the pixels for each part of the image after each exposure. This can be done by moving the camera slightly after each shot. This process is called dithering.
With good calibration frames the pattern can by minimized very slightly. Other than that the only real option for processing I can think of is to hide the pattern by not stretching the dark ares too much.
Other than that great image!
I didn't check but would guess right about one hour. Plus ~30min registration. Normally I just start the process and leave my laptop and come back later, so I don't know for sure.
Absolutely stunning image! Thanks for sharing
Shoot with a Samyang 135mm lens and a Fuji X-T5.
cross-posted from: https://lemmy.world/post/21224914
As I don‘t have a water outlet on my balcony I use a water tank and a pump for watering my strawberries. I developed a controller for the pump which runs natively on Apple Homekit but I‘d like to change it to Matter and Threads in the future.
As I don‘t have a water outlet on my balcony I use a water tank and a pump for watering my strawberries. I developed a controller for the pump which runs natively on Apple Homekit but I‘d like to change it to Matter and Threads in the future.
This was my first try developing my own pcb with the toner transfer method. I did this project many years back but it works perfectly to this day.
It filters an audio signal and drives led strips so they pulsate to the beat of a song.
view more: next ›
Sadly my lens has not perfect back focus, since I‘m using a system camera there is nothing I can change about that. The effect is a little bit compensated with using BlurXTerminator.
The image is cropped a quite a bit, the aspect ratio is still 4:3 however.