49
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 18 Jan 2025
49 points (100.0% liked)
United States | News & Politics
3145 readers
775 users here now
Welcome to [email protected], where you can share and converse about the different things happening all over/about the United States.
If you’re interested in participating, please subscribe.
Rules
Be respectful and civil. No racism/bigotry/hateful speech.
Post anything related to the United States.
founded 2 years ago
MODERATORS
Don't 3D printed guns still need actual gun parts? I didn't think a barrel of a fully 3D printed gun would hold up very long.
Yes, you need to buy some actual gun parts, like a barrel. But, at least as far as 3D printed AR-15s the lower receiver is the only part of the gun that you need to pass a background check for and that can very easily be 3D printed. Literally everything else can be bought online and shipped to your house.
And then there's the FGC9 2.0 (RIP JSTARK), which can be built using only 3d printed and common hardware store parts (including a homemade ECM rifled barrel.)
Metal parts from any hardware store is what I've seen on lemmy.