MissJinx

Do the army support the president even if his orders are against your constitution? How is the overll clima and feeling today?

Just asking because I'm curious, I have no horse in this race :)

Edited to Armed forces since thats exactly what I ment

Two cases of rabies have been attributed to probable aerosol exposures in laboratories, and two cases of rabies have been attributed to possible airborne exposures in caves containing millions of free-tailed bats (Tadarida brasiliensis) in the Southwest. However, alternative infection routes cannot be discounted.

Edit: Thanks to everyone for the help! Just an update.

Thanks to @nate3d and @IMALlama comments below I calibrated the e-steps that were very under and it improved a lot.

I left the filament on the dryer for 8 hours and tested again with a 20mm /s speed and 220 C print temp and it was better (picture below)

Just to answer you all saying it's a clog or a hot end problem, it's not, the whole hot end, includong nozzle, heat block and everything else, even the PTFE tube are all brand new and I checked before.

This is still the best I could achieve and It took 3 hours to print this benchy lol

‐-------- Hi everyone, I'm once again asking for your help lol Since I’ve tried to print with wood I totally wrecked my printer so I changed the hot end and am trying to set it all up again. Since my printer already came built and working I don’t have much experience with things like this so if you could help me I would be very thankful

What do I need to twerk to make it print better again?

I’m using Cura slicer and trying to print a benchy with the settings below:

Nozzle: 0.4

Layer: 0.2

Printing temp: 220 (it wont print with lower temp)

Speed: 60

Retraction distance: 7

Retraction speed: 70

Edit: PLA

This is the temp tower of my wood print experiment Cand even se much difference. It goes from 260 to 190. Below 225 gets really flimsy and above 240 melts. But even 230, the "best" one is really bad, and I'm not talking about retraction. Even the layers that melt are inconsistent.

Also it's not humidity since the filament was in a filament dryer for.16hours.

edit: The nozzle is 0.8

can someone think of anything else?

Didn't even knew there was a shrek book, much less that he had laser-eyes. wtf the book looks better than the movie

"Original Shrek smells so bad that trees lean away from him as he goes by, and he’s so ugly that he can cook food just by glaring at it, with an eye-laser effect that looks exactly like a colored-pencil version of Superman’s heat vision. Shrek also breathes fire and blows smoke out of his ears for fun."

She has 3 different huge cat trees, a cat donut, 2 comfy beds and can sleep anywhere she wants, from couches to our own beds....and I found her sleeping in the dirtiest place in the whole property on top of a cardboard box.

I though they were all spam bots but I saw that some have real users

The legs broke as always but now I just glue the pieces in and it's fine!