These are often found on vacuum cleaner cables and such.
I'd like one to clip onto a two wire (two pronged, no ground) flat cable like this one: 
Anything like that exist yet?
this post was submitted on 18 Feb 2025
36 points (100.0% liked)
3DPrinting
17431 readers
81 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![]()
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I haven't looked to see if one already exists.
But, like someone else said, this would be relatively easy to model.
I would go about it in a different way; here's a quick drawing:
Make the loop for the plug side slightly smaller than the diameter of the cable so it's a super snug fit, and the other side with a large enough gap that you can easily push the cable through it.