3DPrinting

18913 readers

51 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![]()

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

[email protected]

Finally found a way to get Garolite print beds for my Prusa's (lemmynsfw.com)

submitted 2 weeks ago* (last edited 2 weeks ago) by [email protected] to c/[email protected]

7 comments fedilink hide all child comments

So, from my testing while PEI is a fantastic build surface for 3D Printing. It's longevity is rather lacking. I then watched a video from Makers Muse about using G10 for my print bed https://www.youtube.com/watch?v=g0PK4oXbJT8

Problem was (1) how to find G10 in Canada. The answer was look for it under it's industrial marketing name Garolite, which I was able to find. (2) How to make the bottom surface Matte and not ultra glossy. The answer was sanding it down, which had the added benefit of making parts stick better. (3) Sticking it to the print beds.

(3) is where I had a lot of problems. Since my only solution was to use paperclips. It worked on the mark 4 with a loss of 8mm around the print bed edge. However on the Mini it didn't work. 1) The original sheet was too thick, and 2) I needed the original Print Bed underneath for the bed leveling sensor to work.

However today I found my solution. Ripping off the PEI Sheet. It's just adheared with adhesive which once the PEI sheet is removed from, my Garolite sheet can be placed down on top of the original adhesive.

The results so far are fantastic. Garolite doesn't stick to PLA as good as PEI is when new and cleaned. However Garolite sheets lasts a heck of a lot longer and can be cleaned with heavy chemicals like Acetone without issues.

My Mini's bed isn't as levels as I thought it was. However it's nothing a bit of a disc sander can't fix :)

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 3 points 2 weeks ago

I've been using carbon fiber sheets and never had a print move during a print. It's easier to find than garolite. But way pricier. Mind you I didn't shop around. I just saw it, wanted it, bought it. At the same time G10 is pretty shure is used as an electrical insulator inside electrical cabinets what not, so electrical supply places might carry them too