this post was submitted on 29 Feb 2024
242 points (100.0% liked)
3DPrinting
17431 readers
119 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![]()
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I was monitoring this print remotely (Bambu P1S), so I'm not sure what actually happened. It's possible that it failed for other reasons, and then the tool head got tangled in spaghetti and disassembled itself.
I think it's a good added measure to stop a print, in this case something caused the spaghetti, it would have kept causing spaghetti but the cover popping off stopped the print. I've got about 400 hrs on my p1s (upgraded from p1p), and I've never had the faceplate pop off. I would guess this is an isolated incident.
Coult be AI generating the message. Just kidding
It's held in with two fairly strong magnets, I don't think it falls off on its own. If a print falls over and catches on the extruder it could push the front off. I've had it happen for that reason.
Personally..... I'd just have left it off if I was them. I can't imagine a little plastic shield helps hot end temps
I've printed on mine for nearly 1000hrs now, never had an issue with that or prints not sticking. Just have to prep it well and make sure there are no scraps under it.
Normally the toolhead should never hit any object. If it does, and the cover detaches, it can be detected and the printer stopped before any significant damage is caused. Fallen off cover > broken machine.
The cover needs to be detachable to change or replace the hotend, and you need to have the cover for basic protection and better airflow control (I assume), and it's best practice to have a sensor to protect from user error. If the sensor is already there, why not also use it during the print?