23
submitted 1 day ago* (last edited 1 day ago) by [email protected] to c/[email protected]

My phone got some splash water. Unfortunately some water drops landed in the usb charging port. The phone gave me the error message that it detected moisture and i should dry it.

At some point the phone died because of low battery. I did not have charged it yet because of the concernings that the water and charging could damage the phone.

UPDATE: i used paper towels and let it dry overnight. I charged and there was no warnings.

top 22 comments
sorted by: hot top new old
[-] [email protected] 4 points 1 day ago

Forget rice it does not do a good job. You can do a search on it and see.

Time is your best ally with this. Since it’s enclosed, it might take up to a month or more for it to dry out, but it’s the safest method. Our son when he was a baby peed on my wife’s switch. Shop said it was toasted. One year later, it fired up just fine. She just spilled water on her switch light about a month ago and we’re gonna do the same thing with it.

[-] [email protected] 8 points 1 day ago* (last edited 1 day ago)

If it was a few drops of water, using the corner of a paper towel to get into the port and leaving it near a fan or something should dry it fairly quickly.

I'd also recommend using silica gel/desiccant instead of using rice for drying electronics as rice will do jack shit.

[-] [email protected] 12 points 1 day ago* (last edited 1 day ago)

If it's just a few drops in an open port, you could have probably just used a paper towel to wipe it out and then set it in front of a fan for an hour or so to make sure anything left evaporates.

Don't do the rice thing. Then you'll just be getting other dust and crap in the ports.

[-] [email protected] 6 points 1 day ago

I've been to a big water park today, and made a couple underwater pics and vids. Of course I got the "water in usb port" message. Put the phone away (no drying whatsoever), and when I used it again a couple of hours later, I got the message that it was ok to use again. So, I'd guess no worries for you, just try to charge and your phone will check if it's okay yet.

[-] [email protected] 6 points 1 day ago

Best ways to dry it are with a hair dryer on cool setting or with a fan so it can evaporate the moisture.

[-] [email protected] 4 points 1 day ago

Some sources say you shouldn't use a hair drier even on cool, because the high air pressure being forced into it can potentially cause damage. I'm just repeating what I've heard, i don't know if it's accurate or not

[-] [email protected] 2 points 1 day ago

This will depend on the strength of the air setting and how close to the phone they get. Even with the most potent hair dryer on max you wouldn't damage a phone if you keep it half a meter or two feet away from whatever you are drying.

[-] [email protected] 3 points 1 day ago

Avoid using a hair dryer in case it warps plastic or melts solder.

[-] [email protected] 4 points 1 day ago

I dunno, Dad. How long does it take to dry a smartphone?

[-] [email protected] 5 points 1 day ago

About the time it takes to clean your room, go do that and we'll see how dry it gets.

[-] [email protected] 3 points 1 day ago

I had this happen with a phone. It complained about moisture in the charging port for a few weeks whenever plugged in to charge, though after that, would charge for a while before complaining. The charging periods got longer and complaints rarer. The last one was a few months after the incident, and weeks after the previous complaint.

[-] [email protected] 2 points 1 day ago

My phone tells me there's water in the port after I plug it in sometimes.

There's no danger if the phone has hardware to detect the water ingress and software to notify you. My phone when dead has given me this message, and I hit it was canned air like to clean your keyboard. Sometimes, it takes a few tries before the message goes away.

You should be fine to plug it in if you've done your best to dry it. They assume far less careful people than you will be using them.

[-] [email protected] 2 points 1 day ago

If it's only the port on a phone that's at least resistant to water ingress, then it should only be a few hours regardless of what method is used. As long as excess water is shaken out, tiny droplets will evaporate in only a few minutes unless the environment is very humid.

If it's not at least resistant to water, it could take much longer, or already be messed up.

[-] [email protected] 1 points 1 day ago

Air compressor. Be reasonably careful around the speakers though, don't wanna bust the speaker cones.

[-] [email protected] 1 points 1 day ago

Throw it in uncooked rice for 24 hours

[-] [email protected] 8 points 1 day ago

This doesn't do anything. Rice absorbs water on contact, and even then requires heat to do so effectively. Rice does not work like the desiccant packets to reduce ambient humidity in a package.

Rice for any length of time is less effective than just using a paper towel to soak up and large drops externally and setting the phone in front of a fan for an hour.

[-] [email protected] 3 points 1 day ago
[-] [email protected] 2 points 1 day ago

One of these days I’m going to either run an experiment or look up material characteristics of dry rice.

I was under the impression that rice is very capable of absorbing water and that the sheer mass of rice and the fact that you can change it out is an advantage over the paper towel. However because rice becomes soft and sticky during the process it’s inadvisable.

[-] [email protected] 3 points 1 day ago

As I understand it, the rice dies absorb the water - but it leaves behind a bunch of dust that will become sticky over time, potentially causing damage down the road

[-] [email protected] 2 points 1 day ago

Rice doesn't become soft and sticky unless you heat it while it's absorbing water

My family used rice for ages mixed in salt to keep it from clumping. It barely makes a difference. During sustained humid conditions the salt will clump, but the rice never softens or goes sticky.

[-] [email protected] 2 points 1 day ago

Numerous tests have been done about this already. Nearly every tech related blog site has a version of this test somewhere in their archive if you look for it.

The conclusion is always the same, rice is no more effective than just leaving the device sitting on a counter in open air. Having a fan blowing on the device is more effective. The best option is putting it in a container with desiccant gel packets, ideally unused packets. This is what those water damage bags sold at some stores are, they are filled with desiccant beads.

Of course physically opening the device to dry and clean it internally is the most effective, but not something most users can do.

[-] [email protected] 6 points 1 day ago

Then take it out, wipe off soggy ish rice or dust, then make sure there’s nothing lodged where it shouldn’t be. Clean, then clean again. Then realize it’s not clean, so clean again.

this post was submitted on 25 Jul 2025
23 points (100.0% liked)

No Stupid Questions

3149 readers
3 users here now

There is no such thing as a Stupid Question!

Don't be embarrassed of your curiosity; everyone has questions that they may feel uncomfortable asking certain people, so this place gives you a nice area not to be judged about asking it. Everyone here is willing to help.


Reminder that the rules for lemmy.ca still apply!


Thanks for reading all of this, even if you didn't read all of this, and your eye started somewhere else, have a watermelon slice 🍉.


founded 3 years ago
MODERATORS